Can anyone tell me which is the best format of 3d dxf to use if the file is going to be used by Flash for use on a web site.
Should I export 3d mesh, 3d faces or 3d lines?
Cheers
Rob
Advice on 3d dxf export
-
-
What I do:
I export 3d mesh and put it into Acrobat 3d.
This is the best way to handle the model in AdobeReader, you can switch single beams (un)visible or transparent.If I export 3d faces, then you can switch single faces in AdobeReader.
3d lines export only shows lines without faces.
-
Thanks Planer
These dxf's are going to be used in Macromedia Flash. Is the 3d Face option or the 3d mesh option the best for this?
Cheers
Rob
-
Try it out, but I think the result should be the same with both options.
