Mating roof surfaces at Valleys

    Hello,


    I have set up a roof surface property with Vertical Cuts on the eave and on Top End Pent Roof. I also want there to be vertical roof cuts at the valleys.


    What do I have to change in the roof surface property?


    I have attached a picture of the existing valley cuts.
    (or maybe I haven't, I think there may be a problem with attachments)


    Thanks,


    Daniel

    • Offizieller Beitrag

    The cuts at the valleys cannot be changed they are created automaticaly because of the intersection of bothe roof faces. If you have the same slope at bothe roof faces you will get a vertical cut but if you have different slopes you automaticaly will get another angle of the cuts. This is a natural behaviour and there is no other way. A vertical cut would create steps between the slices and this would not be good.

    Viele Grüße,
    Joachim Neumann (Dietrich's AG) :smiling_face_with_sunglasses:
    Software für den Holzbau, Abbund, Holzrahmenbau, Blockbau, Ingenieurholzbau und für die Fertighausindustrie


    if (ahnung == 0) { search "Forum"; read Blog; } else { use brain; make post; }

    • Offizieller Beitrag
    Zitat von dandepoe

    ....
    I have attached a picture of the existing valley cuts.
    (or maybe I haven't, I think there may be a problem with attachments)


    Picture attachments are limited to 1280x1024 pixel. Larger pictures will be ignored.
    Best size is (max.) 640x480, as it is visable without separate download.