My problem is with geometry lines in D-Cam not being in the correct position. I found out...not being in the open GL workspace had incorrect results. In the open GL workspace it is correct. See screen shots. Any Idea why.
Thanks!
Geometry Lines..... Problem
-
-
Showing circles in 3d sometimes causes this problem. The only problem is, that you see the round lines at the wrong place on the screen, but indeed, the lines and snap points are calculated exactly.
-
Der_Planer, My plan was to complete the polygon and extrude it. Is this still possible even though the assisting geometry lines do not appear correct ?
-
Dicam cannot extrude circle lines. Depending on the diameter, these lines are devided automatically into pre-defined straight lines, during extruding.
If you want to control the number of edges, you should not work with circles, but with regular polygons.
-
Der_Planer, The attachment shown with the lines in the open GL workspace shows a closed polygon and will be extruded in the Y direction 4" which does work. Take a look at the same polygon and see how it shows when not in the open GL workspace The goal is a curved bottom chord. I heard this problem will be fixed in my next update I'm currently in version 6.02. One more thing, I understand here in Crivitz, WI USA we have a sister city which is Crivitz, Germany. Would you happen to know where Crivitz, Germany is ? Thanks !
-
Time for update... :wink:
Crivitz-"City", I had not yet heard about it. I looked on the map, and see a small village 2x2 kilometers, and a lot of corn and potato fields around.
It's about 450 km NW from Cologne.
