Hi JMiller,
the process you want to have cannot be done on any Joinery machine. If you want to handcraft it manually in the shop, please use "2-7-1 intersecting volumes".
Best regards,
Jens
Zitat von jmiller....it is hard to get rid of 2-7-1 "notch" later on....
That is not too difficult, did you ever try dicam 3-1-8?
This will delete all "intersection notches" of one beam. (It's not possible to delete them single.)
Joe, to remove cuts or notches made with 2-7-1 use 3-1-8 machine only. But this will remove all of them from the entire beam/timber that you select....
Along these lines - any way to have a valley rafter keep an "ear" or is that also a problem solved only with intersecting volumes? Many thanks!
There is a cutting tool 3-4-9. If the valley rafter meets a rectangular edge of an other beam, it will get an "ear".
I must be too downlevel @ 5.05
8O
Zitat von Der_PlanerThere is a cutting tool 3-4-9. If the valley rafter meets a rectangular edge of an other beam, it will get an "ear".
3-5-9 8O :oops: :oops: :lol: :lol: :lol: :lol: :wink:
:roll: 
It seems, that programmers like to play with numbers and disorder them sometimes... :wink:
Some numbers were changed as the program improved.
Steve, place the valley into the other rafter and use the birdsmouth cut and I may give you the "ear" you want.
Skype me if you need help.
