Slanting rafter into horizontal timber.

This is also made with Dicam 3-8-1, the rafter is number 2.

Delete this operation and use an other:
At the end of a beam do not use 3-8-1 but 3-7-1 and set the first field on "choice".

To help you in your own project, you can save selected elements with 1-1-6 and hang on the compressed file (*.zgb) as attachment.

Zitat von Thorvald

.... I cut the rafter at the inner side of top plates....

Why didn't you select the top side? I think it would bring the correct result.

Now you should understand:

At the end of a beam you can do the same with 3-7-1: