Hi Everyone
Does anyone know if there will be way to define which layer elements from a DLM are placed in. It would be good if you could send them all to say Layer 15.
Cheers
Rob
DLM - Layers
-
-
Hi Rob,
you can do this by using the Dicam function 6-5 MOS Layer. Using this function you can change the layer that any one of your construction elements is assigned to.
Best regards,
Jens
-
Hi Jens
Thanks for the reply. Yes, I realised I could do it this way, I just thought it would be useful to be able to define the destination layer within the DLM parameters.
It would just save a job later on.
Cheers
Rob
