Move

    Is it possible to move a "complete building facade" that consists of different levels containing columns and beams out two feet in D-Cam without having to go into each module and make the move? :roll:


    Kayaker

    • Offizieller Beitrag

    The answer would be easier when I could see what you mean.
    You can push all parts in Dicam, but you must be careful what could happen.
    Maybe there are intelligent connections, so if you push one part, an other will change it's length. Be sure not to push walls, ceilings or roof with Dicam.

    • Offizieller Beitrag

    Hi Kayaker,


    if you try to push a wall with Dicam, you will get a copy, and it becomes a beam. The original wall will stay at it's place. You can use this "function" for special purposes...


    If you push walls in the ground floor, where they are created, then all beams and parts which have the MOS of this wall, will be moved, too.


    In Dicam, it is no problem to move all parts belonging to a wall, but not the wall body itself.