Sloped cut on wall

Kayaker · 29. Mai 2009

I have a wall that I would like to have a sloped cut on top and bottom between roof to roof. Can someone explaine how to accomplish this?

Kind Regards,

Kayaker

Wil Dancey · 29. Mai 2009

Hi Kayaker,

Just change the Wall Type to Dormer Wall. A Dormer Wall is cut between two Roofs You do that in Ground Plan 3-01

In Roof Calculation go to 3-01 to select Roof Properties and select the Roof above to change at what Slice the Wall is cut. Do the same on the Roof below.

Kayaker · 29. Mai 2009

Hi Wil,

Thanks for the help.

Kayaker

Teilen