Markings on Timbers

    Hello,


    This is a simple question. We are trying to place markings of where other beams sit on eachother.


    We have red dashed lines that have come in with some of single beam drawings (when we used birdsmouths), but we are not getting markings on timbers that are sitting in notches (such as purlins sitting on rafters).


    What needs to be specifed?


    Thanks,


    Daniel

    • Offizieller Beitrag

    I am not sure if I understand your problem because my english is not the best.
    We never create markings if two beams are connected with notches because the notch itself fixes the beams. We normaly create markings if two beams are connected with a simple cut but not with a special process.
    To create this type of markings you should use the Marker Assistent.

    Viele Grüße,
    Joachim Neumann (Dietrich's AG) :smiling_face_with_sunglasses:
    Software für den Holzbau, Abbund, Holzrahmenbau, Blockbau, Ingenieurholzbau und für die Fertighausindustrie


    if (ahnung == 0) { search "Forum"; read Blog; } else { use brain; make post; }