Hi again 
I have a few problems when processing jobs, most importantly shorter pieces not being processed correctly (or at all).
In a job like the one shown here, the smaller jacks usually end up either as lengths of timber, or maybe it will put the compound cut on, but not the birdsmouth/rafter foot (or vice versa).
This happens with fairly large pieces too (up to around 700mm), not just tiny ones. The K2 will machine these parts (albiet with some waste, which we dont mind) because I end up programming them manually and running them, it just seems that somewhere along the way they get ignored :?
Is there a setting somewhere where I can tell the post process create them regardless?
I've had a look at the machine settings in DIMAS - but I dont want to mess about with it blindly.
Cheers,
Lee.
::::EDIT::::
Obviously I've checked that the parts are correct within Dietrichs and they are always correct - and they are produced in exactly the same way as the neighbouring jacks which turn out just fine.
:::: ::::
