Hi guys, me again!
Struggling to draw a barn/half/cropped hip in roof calculation.
I can draw a gable or fully hipped roof but not the above..
Any help would be appreciated!
Thanks,
Barn Hip
-
-
Hello Oakcraft,
on the cropped hip side, the eave height should be higher than at the other sides.
Best regards,
Jens
-
Thankyou Jens, it is so simple when you know how!
-
Hello Oakcraft.
You´re welcome. This is what the forum is for.
Regards from sunny bavaria.
Jens
-
Oops, I spoke too soon. Am I doing something wrong since I cannot get the hips to line up with the red lines.
Does this look correct? -
The red lines are only the tiles layer. They will match only if the eaves line properties are "vertical".
Best regards,
Jens
-
Thanks Jens.
Great help!
