Move Purlins

    I would like to move my purlins in roof design slice -1 a specified distance in plan view I see no option to do this. If I move them in plan view in D-Cam, they move out of my roof slice. Is there any way of moving purlins or plates in the roof design module? I know I can go into a 3-D view in D-Cam to relocate them but it would be faster if I could move them in "plan view" in roof design. :roll:


    Thanks!
    Kayaker

    • Offizieller Beitrag

    Hello Kayaker,


    I am not sure if I understand your problem because moving a purlin is no problem.
    Perhaps your Pfette actualy is entered by Obholz and height of plates bottom edge. In this case delete the value for the height and leave the field with <Enter> or arrow key. Then the height will deactivate and you will get the distance in ground active.


    Is that what you are looking for?

    Viele Grüße,
    Joachim Neumann (Dietrich's AG) :smiling_face_with_sunglasses:
    Software für den Holzbau, Abbund, Holzrahmenbau, Blockbau, Ingenieurholzbau und für die Fertighausindustrie


    if (ahnung == 0) { search "Forum"; read Blog; } else { use brain; make post; }