Hi, can someone explain me why I am not able to enter the Wall design module as instructed in the tutorial I am currently following?
I have added a rar file with al my attempts. The most accurate version is to be found in Position 6. The tutorial is instructing me to leave the roof design module and go to the walll design module which for some reason is greyed out.
Hi, thank you for your reply. As previously stated I am running the 10.02 version. A bit earlier in this thread was a link to a PDF-tutorial based on version 4. I have been following this tutorial but have come up with some problems most likeley due to changes that have happened between the severall versions. I was wondering if there are beginner - intermediate tutorials available that are based on a more recent version than verion 4.
Thanks for any kind of information!
Hi,
I have attached an image that show's the description as presented in the PDf tutorial file.
Hi,
In order to continue with a tutorial I am requested to create free walls. Under 2 8. This option however is (no longer) not available to me. Is there something i need to do to enable this option? (I am running version 10.02)
Kind regards,
Bert Neyrinck
Hi,
As a lot of the people here I have just started working with Dietrich. I have a tutorial coursepack of version 7.03. The tutorial starts with the creation of a project frame. In order to start the tutorial i must enter the "free construction mode". How do I do this, If a start a new building position as instructed in the tutorial, I arrive at the "ground plan" mode without the possibility of going to the "free construction mode". This has a different set of options and do not give me the possibility to make a "constant profile", required to continue with the tutorial. I should note (if this is important) that I am running version 10.02.
Thanks in advance for any help possible!
